Can You Install A Pet Door In A Metal Door

Some exterior storm doors are sold with pet doors already installed so you can save some time and energy especially if your exterior doors are due for an update.

Can you install a pet door in a metal door.

Step 2 measure measure where the top of the pet door opening will be. Make sure the pet door frame is secure before you cut and make sure you are cutting in the right groove according to the manufacturers instructions. Step 1 measure up. Once you ve removed all three pins carefully open the door and lift it off the hinges.

Read the fitting instructions that came with your pet door to find out how big the hole in the door should be. Pet doors with flaps and metal security inserts allow your pets to move freely from inside to outside without you needing to open the door. At the same time you should check to see how high above floor level the bottom of the door should be. Additionally it prevents you from working at an awkward angle as you mark and cut the door or try to adjust the pet door installation.

Position the door so that the location of your pet door is clear of the sawhorses and the interior side is facing up. Placing a pet door into a metal door differs from installing one in a wooden door however it is still manageable by following these steps. The convenience a dog door offers far outweighs any concerns or obstacles you may face when installing one. The flap reduces the bugs that can enter the home yet.

The bottom of the pet door should be at least two inches above the bottom of the garage door. How to install a dog door in a metal door step 1. Mark the spot with a pencil. Once the pet door or dog door is in position there is usually a groove in the center of the pet door frame to guide your utility knife as you cut away the screen to make the door opening.

How to install a pet door here are the steps for installing a pet door yourself. Unhinge firstly you will have to take the metal door off its hinges so that it is safer to work on. Lay the door flat on a set of sturdy sawhorses. Use the square to draw perpendicular lines horizontally and vertically marking.

In fact it can be relatively simple.